
Crushing Equipment
Jaw crushers, hammer crushers and roll crushers for raw coal and ore size reduction before washing.
Six equipment families covering crushing, washing, screening, dewatering and product handling — every unit sized against your coal, not against a catalogue.

Jaw crushers, hammer crushers and roll crushers for raw coal and ore size reduction before washing.

Air-pulsated two- and three-stage jigs for power coal, coking coal and gangue recovery, with stable bed stratification and low power draw.

Circular and linear vibrating screens for coal sizing, classification and pre-washing preparation across the full flow sheet.

High-frequency linear dewatering screens that cut fine coal moisture and deliver saleable, stackable product.

Program-controlled chamber filter presses that turn coal slime into handleable cake and close the washing water loop.

Dewatering bucket elevators that lift and drain washed coal in one step, keeping product moisture under control.
Four process-based solutions — from flowsheet design and equipment supply to installation, commissioning and operator training.

Jig-based preparation for utility boilers — raw coal crushing, three-stage air-pulsated jig washing, product dewatering and slime recovery in one closed loop.

Deep washing for coking coal with jig + flotation or dense-medium circuits — precise middlings release, tight moisture control and low product ash.

Thickening, high-pressure filter pressing and full water recycling that turn slime into saleable cake and keep the washing plant at zero discharge.

Dense-medium cyclone and bath separation for difficult-to-wash coal — precise density control, magnetite recovery and medium regeneration as one system.
Tell us your requirements — raw coal capacity, feed size and product target — and our engineers will recommend a suitable setup.
Request a QuoteWe reply with a recommended flow sheet and equipment list — not a generic quotation.
