Thermal Coal Washing Solution

Thermal Coal Washing Solution

Jig-based power coal preparation delivering boiler-grade clean coal from 200,000 to 3,000,000 TPY.

SOLUTION OVERVIEW

Thermal Coal Washing Solution

Power coal usually tolerates higher ash than coking coal, but boilers demand a stable calorific value and a steady supply. A jig-based line gives you the lowest cost per washed tonne: air-pulsated jigs stratify raw coal by density without magnetite, and a three-stage layout handles high-gangue feeds without extra media systems.

The line covers raw coal receiving, crushing and sizing, jig washing, product dewatering and sizing, slime thickening and filter pressing — one supplier, one process responsibility.

200K–3M TPYCapacity range
≤ 9%Typical clean coal ash
98%+Gangue rejection
≤ 65%Circulating water make-up
Process Flow

Typical Process Flow

Six stages from raw coal to loaded product — each engineered against your washability data and plant layout.

  1. Raw Coal Receiving

    Dump hoppers and feeders buffer mine deliveries and even out plant load.

  2. Crushing & Sizing

    Jaw or hammer crushers reduce oversize to the jig’s top size, typically 50–150 mm.

  3. Jig Washing

    Air-pulsated jigs stratify coal and gangue in pulsating water — no magnetite, low power draw.

  4. Dewatering & Sizing

    Dewatering screens and bucket elevators drain lump and smalls to saleable moisture.

  5. Slime Treatment

    Thickener and filter press recover fines as cake; clarified water returns to the circuit.

  6. Product Loading

    Bunkers, conveyors and automatic loading dispatch clean coal to road or rail.

CORE EQUIPMENT

Equipment In This Solution

Manufactured in-house at our 100,000 m² base and trial-run before shipment.

REFERENCES

Related Project Cases

Need a flowsheet for your coal?

Send your washability data and target capacity — our engineers reply with a preliminary flowsheet within 12 hours.

Get Your Plant Design

Get a Quote

Jig machine for coal washing