Get a Quote

Zero liquid discharge means the plant reuses all of its process water and produces only solid cake. It is achieved by balancing water input, water lost with product and water lost with cake — not by adding a treatment unit at the end.
The critical numbers are the moisture content of every output stream. Product moisture, cake moisture and evaporation together must equal the water entering with the feed coal plus any make-up water.
Dehui designs plants toward this balance from the flow sheet stage: dewatering screens and centrifuges on the product side, thickener and filter press on the slime side, and a water balance calculation that closes on paper before anything is built.
Indicative values. Final figures follow from your coal analysis and site conditions.
| Parameter | Typical Range |
|---|---|
| ParameterTypical requirement Water balance | Calculated and closed at design stage |
| Product moisture | Controlled by dewatering screen and centrifuge |
| Cake moisture | Controlled by filter press type and cycle |
| Make-up water | Only what is lost with product and cake |
| Discharge | None in normal operation |
Zero discharge is a mass balance outcome. If the numbers do not close at design stage, no amount of equipment will fix it later.
Rain water and floor wash-down are often overlooked inputs. They can break an otherwise closed balance.
Cake moisture is the largest controllable water loss. A few percentage points here changes the make-up water requirement materially.
Yes for most plants, because the product and cake can absorb the water that enters with the feed. The design has to be checked against your actual moisture figures.
Unaccounted water inputs — rain, wash-down, seal water — and slime output exceeding press capacity.
